Blomberg Washing Machine Error Codes
In case of a malfunction, the appliance will identify the problem by showing an error code on the display.
| Error Codes | Solution |
|---|---|
| E1 | Aqua stop device tripped. Cut off power supply, turn off water tap and contact nearest service centre. |
| E5 | Water not taken in for washing. See point 2 in troubleshooting table. |
| E6 | Water not pumped out. See point 4 in troubleshooting table. |
| OPEN | Door not properly closed. Try reclosing. |
For all the other error codes displayed, cut off the electricity supply, turn off the water tap and contact your nearest Service Centre.
This produce complies with the relevant regulations governing the safety of electrical equipment. For safety reasons, any technical inspections or repairs must be performed by qualified staff, to prevent all hazards for the user.
If the appliance does not work, before calling the After-Sales Service, to avoid unnecessary expense, check yourself that the operations listed in this troubleshooting table have been carried out.
Problem: Appliance does not start
Check that:
- plug is properly connected to socket
- door is securely closed
- “Start/Pause” button has been pressed.
Problem: No water filling
Check that:
- plug is properly connected to socket
- door is securely closed
- water tap is turned on
- water intake hose filters not fouled.
- water intake hose not trapped or kinked
Problem: No water visible in washing drum
No malfunction. The water level is below the level of the glass in the door because new appliances use very little water to achieve the same washing and rinsing results.
Problem: Water not pumped out
Check that:
- drain hose is not kinked.
- drain pump not fouled.
Problem: Water not pumped out after last rinse in delicate fabrics and wool wash programmes
It is not a malfunction: pause programmed into washing programme to prevent creasing of fabrics. To pump out water, proceed as described in “Programme End” point.
Problem: Water takes in and pumps out water continually
Check that end of drain hose is not too low down.
Problem: Strong vibrations during spins
Check that:
- Appliance is properly levelled
- washer-dryer not too close to walls or kitchen units
- internal unit on flexible mounts locked in position.
Problem: Too much foam formed in tank and flowing out of drawer
Check that:
- detergent used is recommended for automatic washing machines and not for hand washing
- quantity used is as stated in manual and no more.
Problem: Water on floor
Check that:
- water intake hose fittings not loose
- end of drain hose still correctly positioned.
Problem: Not all fabric conditioner used or too much water left in compartment
Check that detergent drawer siphons are correctly fitted and not fouled.
Problem: Appliance does not spin
Anti-imbalance safety device tripped because laundry not evenly distributed in drum. If laundry is still wet at end of cycle, rearrange it in the drum by hand and repeat spin programme only.
Problem: Emptying water from drum
In the event of a power blackout or appliance failure, the water can be removed from the drum using the emergency procedure.
Problem: Laundry not properly spun
Large items screwed up and not evenly distributed within drum. Always wash a mix of large and small items.
Problem: Traces of detergent on laundry
Many phosphate-free detergents contain substances with low water solubility. Select Rinse programme or brush the laundry.
Problem: Laundry not dried
Check that:
- water tap is turned on
- load of laundry is not excessive
- drying time is long enough
- appropriate drying time selected.
If the appliance still does not dry the laundry, call the Service Centre to have the fan and drying ducts cleaned to remove any fluff deposits
Problem: Washing results unsatisfactory
- Probably too little detergent or unsuitable detergent used
- Difficult stains not dealt with before washing
- Correct temperature not set
- Basket overloaded.